Limited Inputs when running a Decision Table to create a Test Case
I have been trying to create a Test Case for a specific Decision Table in PEGA, however, there is only one input from 7 showing up. What could make the inputs not be shown during evaluation?
Additionally, if I press "Run Again", everything goes blank, and it does not return anything.
Pegasystems Inc.
IN
@MaxG9380 I believe you are seeing this on the Run dialog of decision table. It shows properties based on different conditions but that does limit in creating a PegaUnit for it. Click on "Convert To Test" to open, create a PegaUnit for it. On the PegaUnit rule form, you will be able to see Decision assertion card which accepts inputs for different properties used in decision table. If a property is not shown on the assertion card, it can be added through "Manage Properties" on top right of the assertion card. Alternatively, properties can also be set from the setup section of the rule form.