Question
Bradesco Seguros
BR
Last activity: 20 Feb 2017 20:59 EST
Simulation Connector SOAP - How work with list of value ?
I am creating a SOAP connector simulation in order to work my construct, since the service is enabled on the target system. But I have the following question:
When I work with simulator for SOAP connector, I need to create an Activity that will be responsible for simulating the return of my service.
The service I'm trying to simulate returns a list of values as response. I'm using the Property-Set method, however from what I've seen it can only list one value per property.
How could I create a SOAP connector simulation, creating a list of values in response?
***Updated by moderator: Lochan to add Categories***
Accepted Solution
Pegasystems Inc.
IN
Hello!
The user had replied over a private message to the moderators that this has been resolved with the below changes!
One alternative that was used in this case, was to identify which fields were page lists and which the fields weren't.
In this case identifying the position, I made the set parameter in the activity, as follows:
TestField (1) .name
TestField (2) .LastName
WhereTestField is my page list and the next field is a default value. This way it was possible at the time to run the simulator, to make it understand that it was to set a list of values.
Regards,
Pegasystems Inc.
IN
Hello
Not sure if i have understand your question correctly or not. But do you think using for each loop in your activity will help ?
Refer this
Accepted Solution
Pegasystems Inc.
IN
Hello!
The user had replied over a private message to the moderators that this has been resolved with the below changes!
One alternative that was used in this case, was to identify which fields were page lists and which the fields weren't.
In this case identifying the position, I made the set parameter in the activity, as follows:
TestField (1) .name
TestField (2) .LastName
WhereTestField is my page list and the next field is a default value. This way it was possible at the time to run the simulator, to make it understand that it was to set a list of values.
Regards,