Question
IBM
CN
Last activity: 5 Apr 2023 4:58 EDT
Fail to see DT parameter by a Gear icon
Hello,
Scenario is:
DT A call DT B.
DT B was checked out to a branch and was added a new input parameter (not required), then was checked in in the branch.
DT A is not in a branch.
Then I fail to see DT B parameter by a Gear icon in DT A in the step calling B, as below image.
May I know the reason? Thanks.
F.y.i, the 2 DTs are running normally as expected.
Evonsys
IN
@MaxonL16591286 can you remove the DT B from DT A and again select DT B from the autocomplete. Then can you check if the parameters are there?
Updated: 5 Apr 2023 4:40 EDT
IBM
CN
@Anoop Krishna
I do below and still same issue:
- Either Private Edit DT A or Check out DT A to a branch.
- In DT A, remove the step calling DT B
- Add a same "Apply Data Transform" step calling select DT B, the name of DT B is selected from the autocomplete dropdown list.
F.y.i. DT A/B are in same class of a case type.
Thanks.
Coforge
IN
HI @MaxonL16591286 can you check below mention points once :
DT B is saved in the same branch ruleset as of the main ruleset.
check ruleset stack of your operator profile (go to operator -> profile), see whether that branch ruleset is in top of the stack.
Check Validation mode of the main ruleset.
Evonsys
IN
@MaxonL16591286 Is that branch added to the application?