Question
IBM
HK
Last activity: 10 Jan 2023 22:55 EST
Create two user pages in clipboard
If I want to create two sections in one panel for case worker to work on:
CaseInitiator (Read only) content 123
CaseWorker (Editable) content 123
The contents of two sections are same with different settings.
Is it possible to show two pyWorkpage on clipboard, or show two child pages under pyWorkpage?
***Edited by Moderator Marije to add Capability tags***
NCS Pte. Ltd
SG
Hi @SandyP16637557: From the above I feel case participants would be the a good choice.
Refer : https://docs-previous.pega.com/case-management/86/defining-case-participants?
Default perform harness will have options for updating the participants (in 8.7 it will be as Stakeholders)
Another option is to use the default pyWorkParty page to load the details of your sections.
If the above are not satisfying your requirement, you can create a property in your work class (mode page / page group) of type data class (try to use party class) and embed your own sections. When embedding sections, you can add read only conditions based on your requirement. ( you should initiate the pages to load the sections.)
Few ref for embedding sections from different class as below:
https://support.pega.com/question/section-data-class-does-not-appear-work-class
https://support.pega.com/question/embed-data-class-section-work-class-section
Thanks.
IBM
HK
Thanks for your reply.
I have another question, after i created a new data class and two single page property under the class.
I used two embedded sections and call the same value into it.
Then when i run the case, the clipboard showed two sub-pages as expected.
However, the value is not shown in the UI
NCS Pte. Ltd
SG
Hi @SandyP16637557: Are you able to see the values for properties in the clipboard? If the values are available in the clipboard and if it is not shown in the UI, i suspect some configuration issue in your section rule. If the clipboard itself don't have values, you need to initialize them. If this is taken care, can you share your section configuration? (without confidential data)
Thanks.