Skip to main content

This content is closed to future replies and is no longer being maintained or updated.
Links may no longer function. If you have a similar request, please write a new post.

Question

 Mohamad Bachir Sidani (msidani)
Murex
Senior Software Developer
Murex
LB
msidani Member since 2016 28 posts
Murex
Posted: Jun 28, 2016
Last activity: Jun 28, 2016
Posted: 28 Jun 2016 5:09 EDT
Last activity: 28 Jun 2016 5:30 EDT
Closed
Solved

change report definition depending on a condition

Hi,

I have a grid in one of my stages. and I have 2 report definitions.

I want to check my stage name. If it is new i want to source my grid to read from report definition 1. if it is other than new I want this grid to read from report definition2. How is this possible?

Thanks!

Message was edited by: Lochan to add Category

To see attachments, please log in.
Case Management
Reporting

  • Kanstantsin Krylovich

Accepted Solution

Posted: 8 years ago
Posted: 28 Jun 2016 5:27 EDT
Mahesh Midthuru (Mahesh Midthuru)
PEGA
Senior Principal Application Engineer, Customer Service Digital
Pegasystems Inc.
US

Hi Mohammad,

I think you can write two repeat grids with the corresponding report definitions and try to configure the repeat grid visibility based on your condition which grid to be displayed based on the state as shown below,

GridSettings.png


So i believe based on the grid visibility filter you can show the corresponding grid as per your requirement. Hope this idea might be helpful to achieve your requirement.

Regards,

Mahesh

To see attachments, please log in.

We'd prefer it if you saw us at our best.

Pega Collaboration Center has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice